盛源彩票计划群

全自动点胶机的效果受哪些因素影响?

发布时间:2020/08/28    发布人:

 很多企业买了点胶机但是始终没有点出点胶机厂家的效果,那是为什么呢,下面双组份打胶机就为大家介绍一下

  Many enterprises have bought dispensing machines, but they never point out the effect of dispensing machine manufacturers。 That's why。 Now two-component dispensing machine is introduced to you。

  1、点胶量

盛源彩票计划群  1。 dispensing quantity

  点胶量一般是由点胶时间来控制的,时间越长胶量越大。

  The dispensing amount is generally controlled by the dispensing time, the longer the dispensing time is, the larger the dispensing amount is.

  2、气压和速度

盛源彩票计划群  2. Pressure and velocity

  气压大,胶水流动速度快,胶量过多会溢出,气压小,胶水流动速度慢,胶量则会过少甚至出现点胶中断或者漏点。运动速度正好相反。因此,需根据不同的气压调整运行速度

  The pressure is high, the glue flow speed is fast, the glue overflow will occur if the glue quantity is too much, the pressure is low, the glue flow speed is slow, and the glue quantity will be too little or even the dispensing interruption or leakage point will occur. The speed of motion is just the opposite. Therefore, it is necessary to adjust the operating speed according to different atmospheric pressure.

  3、针头

  3. Needle

  点胶过程中,应该根据产品大小来选择针头。有时也会根据不同的胶水选择针头。

  During dispensing, needles should be selected according to product size. Sometimes needles are selected according to different glue.
 

  4、环境

  4, environment

  胶水的粘稠度会影响点胶的质量。粘度大点胶大,粘度小点胶小,一般情况下,需保持点胶机处于温度23-25摄氏度的环境下,温度过低胶水粘度增加,反之则降低。

  The consistency of glue will affect the quality of dispensing。 Large viscosity dispensing, small viscosity dispensing small, generally, need to keep dispensing machine in the temperature of 23-25 degrees Celsius environment, temperature too low glue viscosity increases, otherwise decreases。

  5、气泡

  5. Bubbles

  胶水要保证没有气泡。一个很小的气泡就有可能导致出现残次品或者没点到胶,所以每次更换胶管的时候一定要排空连接处的空气,防止出现空打现象。

  Glue should be guaranteed free of bubbles。 A very small bubble may lead to defective products or no glue, so every time you change the hose, you must empty the air at the junction to prevent air beating。

极速赛车是哪里的 广西快3走势 全民彩票计划群 极速赛车记录 必发彩票计划群 河北快3 吉林快3 福建11选5开奖 极速赛车怎么赢钱 久赢国际计划群